HiModel
FRSKY TWO-WAY 2.4G FUTABA COMPATIBLE RADIO SYSTEM TELEMETRY DFT/D8R-II PLUS
FrSky provides an ..." />
| Model | DFT |
| Operating Voltage Range | 6.0V-13.0V |
| Operating Current | 50mA |
| Output Power | 60mW |
| Resolution | 11bit (3072) |
| Futaba | 3PM, 3PK, 7U, 8U, 8J, 9C, 9Z, 10C, FN series, T10C, FC-18, FC-28. |
| Hitec | Optic 6, Eclipse 7, Prism 7. |
| WFLY | WFT09, WFT08. |
| Model | D8R-II Plus |
| Weight | 16.2g |
| Dimension | 54*27*17mm |
| Operating Voltage Range | 4.0V-7.2V |
| Operating Current | 100mA |
| Specified Range | 1.5km (Ground Range) |
| Resolution | 11bit (3072) |
| Latency | 22ms |
| Number of Channels | 8CH |
| Analog voltage | 0~3.3V |
, , , , , , Specifications:, , , , , , , , , , , Transmitter module specifications:, Compatible with the following transmitters:, Receiver specifications:, , ,
Features: The Two-way Radio System developed by FrSky provides an ...2 Reviews
HiModel
FRSKY TWO-WAY 2.4G DHT MODULE - TOGGLE SWITCH VERSION
| Operating Voltage Range | 6.0V-13.0V |
| Operating Current | 50mA |
| Output Power | 60mW |
| Resolution | 3072 (>11bit) |
, , , , , , , , Features:, , , , , , , , , , , THIS IS THE NEW TOGGLE SWITCH VERSION DHT., 1.1 Compatibility:, Switch 1, , Switch 2, , Mode of DHT, , Compatibility, , OFF, , OFF, , Two-way Mode, , Two way telemetry receivers (D8R, D6FR), , OFF, , ON, , V8 Mode, , V8 receivers (V8FR-HV, V8R7-HV, V8R7-SP, V8R4), , 1.2 Specifications:, 2. Setup, 2.1 Installation process:, 1）Open the transmitter, find out Battery power supply line, PPM signal line, and GND., 2）Take the order and solder Battery power supply line, PPM signal line, and GND to DHT with 3 wires., (RED→V+; BLACK→GND; YELLOW→PPM), 3）Drill one hole on the transmitter to install the PCB with F/S button, GREEN/RED LED and two switches., 4）Connect the antenna connector at the port on transmitter board., 5）Drill a hole for antenna connector at suitable space on the transmitter (diameter 7mm is suitable)., 6）Fix the transmitter antenna on the connector .Turn the transmitter power on and check the power indicator LED, which is normally light RED., 2.2 Bind procedure, 1）Turn your transmitter on and switch it to PPM mode. Turn your transmitter off., 2） Turn your transmitter on while holding the F/S button on the transmitter module (Please make sure DHT is in its corresponding mode when working with V8 or two way telemetry receivers). Release it in a few seconds. The RED LED on the transmitter module will flash, indicating the transmitter is ready to bind the receiver., 3）Connect battery to the receiver while holding the F/S button on the receiver. The RED LED on the receiver will flash, indicating the binding process is completed., 4）Turn on the transmitter and re-connect battery to the receiver. The RED SOLID LED on the receiver will indicate the receiver is receiving commands from the transmitter., 5）After the above steps are completed, both the transmitter and the receiver are ready to be used., Notice: When working with two way telemetry receivers (D8R or D6FR), please kindly make sure that the battery ,
Features: THIS IS THE NEW TOGGLE SWITCH VERSION DHT. 1.1 ...1 Reviews
HiModel
FRSKY 2.4G 10-CHANNEL TF RECEIVER TFRSP
FrSky ..." />
| Number of Channels | up to 10 channels (CPPM for CH1~CH9, servo signal for CH5~CH10) |
| Operating Voltage Range | 3.5V~10V |
| Dimension | 53mm*30mm*11mm |
| Weight | 13.5g |
| Note | Increased duty means good signal reception, and vice verse. |
, , , , , , Specifications:, , , , , , , , , , , Specifications:, With RSSI Output, *CPPM is usable for reducing wirings to some flybar-less controllers, autopilot systems and homebrew UAV systems. Furthermore, it can be used as a wireless trainer system., Warning: Servos are not to be plugged into Channel CPPM and Channel RSSI, otherwise servos will get hot or may burn out., , ,
Features: Compatibility: FASST 2.4G: Air Systems (7CH Mode/Multi Mode) FrSky ...HiModel
FRSKY TWO-WAY 2.4G JR COMPATIBLE RADIO SYSTEM TELEMETRY DJT/D8R-II V2
FrSky provides an ..." />
| Model | DJT |
| Operating Voltage Range | 6.0V-13.0V |
| Operating Current | 50mA |
| Output Power | 60mW |
| Resolution | 11bit (3072) |
| Model | D8R |
| Weight | 16.2g |
| Dimension | 54*27*17mm |
| Operating Voltage Range | 4.0V-7.2V |
| Operating Current | 100mA |
| Specified Range | 1.5km (Ground Range) |
| Resolution | 11bit (3072) |
| Latency | 22ms |
| Number of Channels | 8CH |
| Analog voltage | 0~3.3V |
, , , , , , Specifications:, , , , , , , , , , , Transmitter module specifications:, Compatible with the following transmitters:, JR: 347/388/783/U8/PCM10/PCM10S/PCM10SX/, PCM10IIS/8103/J9303/MX-22/MX-24S/PX/9XII., Receiver specifications:, , ,
Features: The Two-way Radio System developed by FrSky provides an ...2 Reviews
HiModel
FRSKY 2.4G 7-CHANNEL FUTABA FASST COMPATIBLE TF RECEIVER TFR6
FrSky 2.4G 7-channel Futaba FASST Compatible TF Receiver TFR6 ..." />
| Operating Voltage Range | 3.5V~10V |
| Dimension | 37x22x8mm |
| Weight | 7.8g |
, , , , , , Specifications:, , , , , , , , , , , Number of Channels: 7, , ,
Features: FrSky 2.4G 7-channel Futaba FASST Compatible TF Receiver TFR6 ...HiModel
FRSKY 2.4G 7-CHANNEL FUTABA FASST COMPATIBLE TF RECEIVER TFR6-A (SIDE PIN)
FrSky 2.4G 7-channel Futaba FASST Compatible TF Receiver TFR6-A, ..." />
| Operating Voltage Range | 3.5V~10V |
| Dimension | 37x22x8mm |
| Weight | 7.8g |
, , , , , , Specifications:, , , , , , , , , , , Number of Channels: 7, , ,
Features: FrSky 2.4G 7-channel Futaba FASST Compatible TF Receiver TFR6-A, ...HiModel
FRSKY 2.4G 4-CHANNEL FUTABA FASST COMPATIBLE TF RECEIVER TFR4
FrSky 2.4G 4-channel Futaba FASST Compatible TF Receiver TFR4 ..." />
| Operating Voltage Range | 3.5V~10V |
| Operating Temperature Range | -10℃~80℃ |
| Dimension | 34x19x8mm |
| Weight | 6.2g |
, , , , , , Specifications:, , , , , , , , , , , Number of Channels: 4, Comparison Chart for TFR4/TFR6, , , TFR4, , TFR6, , Dimension, , 34*19*8mm, , 37*22*8mm, , Weight, , 6.2g, , 7.8g, , Compatibility, , Air systems (7Ch mode & Multi mode), , √, , √, , Ground systems (3PK, 4PK in C1 mode), , √, , , , Capable of using native failsafe position on Tx side, , √, , √, , Combined PPM to set up as Wireless Trainer System, , √, , , , RSSI, , √, , , , , ,
Features: FrSky 2.4G 4-channel Futaba FASST Compatible TF Receiver TFR4 ...HiModel
FRSKY 2.4G 8-CHANNEL FUTABA FASST COMPATIBLE TF RECEIVER W/RSSI & SB PORTSTFR8SB
FRSKY FASST 8-CH RECEIVER TFR8SB VERSION. ..." />
| Model | TFR8SB (8ch FASST compatible receiver with RSSI & SB ports) |
| Weight | 11.5g |
| Dimension | 44.5x 27.5 x 17mm |
| Operating Voltage Range | 3.5V-10.0V |
| Servo Frame rate | 14ms (FS - normal speed mode) |
, , , , , , Specifications:, , , , , , , , , , , Number of Channels: 8, 7ms (HS - high speed mode), , ,
Features: THIS IS THE FRSKY FASST 8-CH RECEIVER TFR8SB VERSION. ...HiModel
FRSKY 2.4G FUTABA COMPATIBLE RF MODULE (TWO-WAY) & RECEIVERS COMBO DFT/V8FR
| Operating Voltage Range | 4.8V-6V |
| Operating Current | 30mA |
| Specified Range | 1.2km |
| Resolution | 10bit |
| Latency | 22ms |
| Number of Channels | 8CH |
| Dimensions | 60×37×21 mm |
| Model | DFT, two-way telemetry module |
| Operating Voltage Range | 6.0V-13.0V |
| Operating Current | 50mA |
| Output Power | 60mW |
| Resolution | 11bit (3072) |
| Futaba | 3PM, 3PK, 7U, 8U, 8J, 9C, 9Z, 10C, FN series, T10C, FC-18, FC-28. |
| Hitec | Optic 6, Eclipse 7, Prism 7. |
| WFLY | WFT09, WFT08. |
, , , , , , Specifications:, , , , , , , , , , , Receiver specifications:, Transmitter module specifications:, Compatible with the following transmitters:, , ,
Features: ◆ Advanced Continuous Channel Shifting Technology ( ACCST SYSTEM) ...4 Reviews
HiModel
FRSKY 2.4G JR COMPATIBLE RF MODULE (TWO-WAY) & RECEIVER COMBO DJT/V8FR-HV
| Operating Voltage Range | 4.8V-6V |
| Operating Current | 30mA |
| Specified Range | 1.2km |
| Resolution | 10bit |
| Latency | 22ms |
| Number of Channels | 8CH |
| Dimensions | 60×37×21 mm |
| Operating Voltage Range | 6.0V-13.0V |
| Operating Current | 50mA |
| Output Power | 60mW |
| Resolution | 10bit |
| Dimensions | 63.9X48.5X36.5mm (V8JT); |
, , , , , , Specifications:, , , , , , , , , , , Receiver specifications:, Transmitter module specifications:, , ,
Features: * The RF module of this combo was upgraded ...3 Reviews
HiModel
FRSKY FUEL SENSOR FGS-01
| Measurement Levels | Empty, 1/4, 2/4, 3/4, Full |
| Length of the Sensor Film | 62mm |
, , , , , , Specifications:, , , , , , , , , , , Installation: Use double-sided tape to attach both circuit board and sensor film firmly to the outside of the fuel tank., How to replace the sensor film:, Lift the locking tab on both sides of the port, insert the sensor film and press the locking tab back into place to secure the sensor film in the circuit board. Confirm the orientation is correct., Note:, The fuel tank MUST be empty at the start of this process for the sensor to accurately read the fuel level., , ,
Features: Different sensors facilitate to monitor different data, such as ...HiModel
FRSKY GPS MODUEL GPS-01
| Longitude | dddmm.mmmm E/W |
| Latitude | ddmm.mmmm N/S |
| Installation | Use double-sided tape to install the GPS on any appropriate surface of the airframe. |
| Note | Up right position is recommended. |
, , , , , , Specifications:, , , , , , , , , , , GPS feedbacks various data, such as speed, longitude and latitude., Note:, , ,
Features: Different sensors facilitate to monitor different data, such as ...HiModel
FRSKY VARIOMETER SENSOR FVAS-01
| Measurement Range of Altitude | 0~9000m |
| Installation | Use double-sided tape to install the variometer sensor on any appropriate surface of the airframe. |
| Note | Wind will affect the altitude reading. |
, , , , , , Specifications:, , , , , , , , , , , Accuracy: 1m, , ,
Features: Different sensors facilitate to monitor different data, such as ...HiModel
FRSKY TEMPERATURE SENSOR TEMS-01
| Accuracy | 1 degree Celsius/ 1 degree Fahrenheit |
, , , , , , Specifications:, , , , , , , , , , , Up to two temperature sensors can be used at the same time. They are commonly used to read temperatures of model accessories, such as electric motor, ESC, glow and gas engine cylinder head, battery, muffler, voltage regulator, BEC, tailpipe and ambient air. Measurement Range: -30~250 degrees Celsius/ -22~482 degrees Fahrenheit, Installation: Use zip ties to hold the temperature sensor tightly against the accessory that requires temperature reading., , ,
Features: Different sensors facilitate to monitor different data, such as ...HiModel
FRSKY RPM SENSOR RPMS-01
| Measurement Range | 0~50000r/min |
| Installation | Point the RPM sensor straight up at any accessory that requires RPM reading. |
| Note | Indoor alternating current lighting will affect the RPM reading. |
, , , , , , Specifications:, , , , , , , , , , , RPM sensor reads RPM data by using an optical sensor., , ,
Features: Different sensors facilitate to monitor different data, such as ...